The iron barrel flattening machine
uses 68# hydraulic oil, connected to the power supply, three-phase 380V, and rated current 25A. The grounding protection must be provided during installation. The motor must be operated according to the direction shown before it can be activated, otherwise it cannot be started. Add hydraulic oil to the oil tank to start use. However, when the temperature drops, the hydraulic oil concentration is high, and the filter in the machine cannot play a filtering role. At this time, the filter must be removed and the temperature can be restored before it can be installed and used. (Note: The filter should be cleaned 1-2 times a month). Overflow raft-control the pressure switch of the machine, turn the pressure regulator to the right to increase pressure, and to the left to reduce pressure. The pressure has been adjusted before leaving the factory. However, the pressure regulating handwheel may be displaced during use, resulting in pressure increase or decrease. At this time, a new regulating pressure needs to be generated. The pressure regulation should be carried out during operation. At the same time, the pressure plate should be lowered to a low position to adjust the overflow. With the pressure regulating hand wheel of the raft, the regulating pressure cannot be higher or lower than the range indicated by the pressure gauge, and the pressure is OMPA (100KG/1cm2). The side rod enhances the rigidity of the pressure and plays a guiding role. Oil should be added before each use for lubrication. Travel switch-the function of controlling the start and stop of the machine, so it must be checked, repaired and maintained frequently. Manual steering valve-a switch that controls the pressure plate up and down to stop.
In summary, the correct and reasonable use of the Nick brand iron barrel flattening machine, timely inspection and maintenance, can extend the service life of the iron barrel flattening machine, and the machine will work better for you.