Maintenance and adjustment of metal crusher
Scrap iron baler, scrap steel baler, scrap metal baler
We ensure the normal operation of the machine and the efficiency of the machine during the use of the equipment. In order to ensure the good use of the equipment, we must also master the correct adjustment method in the process of replacing metal crusher parts.
1. Replacement of wearing parts: When replacing wearing parts of the paint bucket crusher, first open it and put it on the shelf. When in use, first remove the connecting bolts between the rear upper frame and the middle box, and then use a wrench to screw the hexagon head part of the flip device, and then slowly open the upper frame. At the same time, you can use the hanging device above the rack to hang the rear rack, repeat the above process, that is, put it on the rack after closing it.
2. Blow bar: When the counterattack blow bar is worn to a certain extent, it should be adjusted or replaced in time to prevent damage to fasteners and other components.
3. Lining plate: Open the rear upper cover, undo the cotter pins, slotted nuts and bolts used to fix the impact lining, and then replace the worn impact lining. If a new impact lining is installed, immediately reverse the above process .
4. Bearings: Too high temperature may be caused by excessive or insufficient grease, dirty grease, and damaged bearings. Replacement of bearings is a key step in the sand making production line.
5. Adjustment of the gap between the rotor and the counter-attack liner: When the rotor of the Guangzhou paint barrel crusher is in operation, the gap between the rotor and the counter-attack liner cannot be adjusted.
Nick Machinery has continuously accumulated experience in the use of metal balers, and has mastered relevant skills and knowledge, so that metal balers can better complete tasks. https://www.nkbaler.com
Post time: Sep-28-2023