Straw baler oil tank design
straw baler, wheat baler, corn baler
The design of the oil tank structure of the straw baler is to better avoid the pollution of the hydraulic oil to the environment. The gear oil of the straw baler is often polluted by the environment. In order to better ensure that the gear oil of the straw baler can be used for a longer time, so Therefore, the fuel tank design of the straw baler must be more effective in order to maintain the service life of the mechanical equipment.
1. The distance between the suction oil pipe and the oil return pipe should be as far as possible, the oil removal side should be separated from the pump side, and a baffle should be used to improve the cleanliness of the oil discharge pipe.
2. A coarse filter device must be installed at the inlet of the suction pipe. When the liquid level is low, both the filter device and the end of the oil return pipe should be immersed in the oil.
3. In order to avoid pollution, the fuel tank, rear plate and support pipe must be properly sealed, the fuel pump should be equipped with a filter, and an air filter should be installed on the fuel tank.
4. In order to better dissipate heat and facilitate maintenance, the distance between the bottom box and the road should generally be more than 150mm.
5. The outer wall of the large-space fuel tank generally needs to open the cleaning dialog box, and the cleaning dialog box is usually cleaned by sealing the side cover.
Nick's straw baler has reasonable planning, takes up little space, and conforms to the concept of environmental protection. It is your ideal choice. Nick hopes to cooperate with you to contribute to environmental protection. https://www.nkbaler.com
Post time: Nov-10-2023