Installation process of plastic bottle baler
Plastic bottle Baling Press machine, can Baling Press machine, mineral water bottle Baling Press machine
When the plastic bottle baler is used normally, it is strictly forbidden to disassemble the hydraulic oil pump. The oil used in the hydraulic transmission system of the plastic baler is particularly small in compressibility. Under normal circumstances, their harm is almost negligible. Therefore, even with a little air, it will have a great impact on the plastic baler. In this case, what aspects need to be considered during the installation of the plastic baler?
1. Set the exhaust valve above the oil cylinder of the plastic baler, which is beneficial to dry out the air in the oil cylinder and the system. The oil temperature change and load change of the plastic baler exceed the change of the throttling cutting.
2. It should be avoided as much as possible that the pressure in the plastic baler system should be lower than the atmospheric pressure. At the same time, a special high-quality sealing device should be selected. If there is an abnormality, it should be replaced in time. The pipe joints and joint surfaces must be screwed, and the plastic baler oil tank should be cleaned in time. Oil filter at the inlet.
3. In daily work, often check the height of the oil level in the tank of the plastic baler, and its height should be kept on the oil mark line. The lower surface, the mouth of the suction pipe and the mouth of the same nozzle are also guaranteed to be below the liquid level, and must be separated by a partition. If an accident occurs, please stop running immediately.
The above three points are related to the three key points that Guanqian plastic baler needs to consider during the installation process. If you have any questions, you can consult from the website of Nick Machinery, https://www.nkbaler.com
Post time: Sep-25-2023