What preparations need to be made before restarting the baler?

Before restarting a baler that has not been used for a long time, the following preparations are required:
1. Check the overall condition of the baler to make sure it is not damaged or rusted. If a problem is found, it needs to be repaired first.
2. Clean the dust and debris inside and outside the baler to avoid affecting the normal operation of the machine.
3. Check the lubrication system of the baler to ensure that the lubricating oil is sufficient and free of contamination. If necessary, change the lubricant.
4. Check the electrical system of the baler to ensure that the circuit connections are normal and there is no short circuit or leakage.
5. Check the transmission system of the baler to ensure that there is no wear or slack in transmission components such as belts and chains.
6. Check the blades, rollers and other key components of the baler to ensure their sharpness and integrity.
7. Conduct a no-load test run of the baler to observe whether the machine runs smoothly and whether there are any abnormal sounds.
8. According to the operation manual, adjust and set the baler to ensure that its working parameters meet the requirements.
9. Prepare enough packing materials, such as plastic ropes, nets, etc.
10. Make sure the operator is familiar with the operation method and safety precautions of the baler.

After carrying out the above preparations, the baler can be restarted and put into use. During use, regular inspection and maintenance are required to ensure the normal operation of the baler.